Inspection & Measuring Stations |
|
With today's quality demands, a good inspection system can
actually save money. The justification for 100% inspection is easy
when considering an out-of-specification part reaching your customer
could result in thousands of dollars in additional expenses (i.e.
sending representatives on-site and hand inspecting every part).
|
|
OD Laser
This station measures the outside diameter of the bushings at
one or more cross section points along its axial length. This is
a 100% inspection system. The OD Laser consists of two laser scan
micrometer systems. The resolution of the system enables accurate
measurement of the bushing diameter to .001 mm.
|
 |
Height Check
The Height Check Station verifies the inner metal axial length
is within specification and the relationship between the inner metal
and the outer metal is within specification. |
 |
Bond/ID Check
This station combines the ability to verify the inside diameter
and the ability to locate bushings that have not bonded properly
to the inner or outer metal. |
 |
Intermediate Metal Check
The Intermediate Metal Check Station is a station that checks
to ensure than an intermediate metal or rate plates are present
in the molded part. |
 |
| |
|
For more information about measuring
applications Contact CAE. |
| |
|
